ayatec logo
Home Store Blog Contact
unicontrol user guide by ayatec
Home Store Blog Contact

Topics

  1. Welcome
  2. Getting started
    1. What is unicontrol
    2. How it works
    3. Connectivity
    4. Integration options
    5. Default hardware
    6. Hardware extensions
    7. Special sensors
    8. RGB driver
    9. Audio driver
    10. Network API - HTTP
    11. Network API - MQTT
    12. Network security
    13. Downloads
  3. Web Interface
    1. Processes
      1. Process
      2. Name
      3. Main state
      4. Initial state
      5. Display
      6. Constraints
        1. Process timer
        2. Variable contraints
        3. Force output
      7. Input
        1. Input source
        2. Channel
        3. Control period
        4. Value
        5. Publish
        6. Frequency
        7. Subtopic
      8. Events
        1. On/Off event
        2. Condition
        3. Idle/running time
        4. Delay on/off
        5. Fade in/out
        6. High/low input
        7. Mid point/Tolerance
        8. Out on when
      9. Output
        1. Primary output
        2. Action
        3. Type
        4. Invert
        5. Duty cycle
        6. Mem value
        7. High/low output
        8. Folder/Track
        9. RGB mode
        10. RGB color
        11. RGB brightness
        12. RGB speed
        13. Publish
        14. Subtopic
        15. Secondary outputs
      10. Cycle
        1. Cycles
        2. High/Low phase
      11. On/Off button
    2. Peripheral
      1. Hardware
      2. Type
      3. Calibration
      4. Mapping (edit)
      5. IR remote (edit)
      6. Impulse_counter (edit)
      7. RGB driver (edit)
      8. DS18B20 (edit)
    3. Device
    4. Network
    5. System
    6. License
  4. Tutorials
    1. First boot
    2. First process
    3. Connect to MQTT
    4. Process sequencing
    5. DIY Project: Bath Fan

In this article

  • Introduction
advert
unicontrol > Web interface > Processes > Events

Events

The unicontrol's operation is based on Events, making them the key aspect of the program's decision-making process and output control. The Events section enables the user to configure these events.

The On/Off event parameter currently offers five options: Rising edge, Falling edge, Condition, Timeout, and Analog link. Each option has a unique set of available parameters. Please refer to the table below for all available combinations.

Parameter Rising edge Falling edge Condition Timeout Analog link
Delay✓✓✓
Fader *✓✓✓✓
Idle/Running time✓
Condition✓
High/Low input✓
* only appears when the PWM output is enabled.

Except for the Analog link, all Event options allow for independent set-up of the On event and Off event, while each of the Event options listed above has a distinct set of available parameters. Please, check all available combinations in the table below.

© 2024 ayatec.eu • Found a mistake?  Let us know!